#ifndef HARDWARE_H
#define HARDWARE_H
/*================================================================================================
 
 hardware.h 						SiWiCom copyright 2006						v1.0 (2006-05-04)
 
 Name: Joakim Nilsson				E-mail: mail@jopin.se
 Name: Christoffer Martinsson		E-mail: cm@cmtec.se

 Description: Pin and port definitions of Atmel ATMega48 in project SiWiCom		
 
================================================================================================*/
/*===============================================================================================
 Definition of CPU speed (needed for delay routine)
================================================================================================*/
#define F_CPU 1000000UL

/*===============================================================================================
 Definition of SPI routines
================================================================================================*/
#define SPI_PORT		PORTB	// PORTB as SPI-port
#define SPI_PIN			PINB
#define SPI_DDR			DDRB	// DDRB as direction for SPI pindirection

#define MOSI 			PB3		// Master Out - Slave In
#define MISO 			PB4		// Master In - Slave Out
#define SCK	 			PB5		// Serial Clock
#define SS	 			PB2		// Slave select
/*SPI-master or SPI-slave config*/
#define _SPI_MASTER_
//#define _SPI_SLAVE_

/*Chip select configuration*/
#define SPI_CS0_PORT	PORTB	//CS0 on portB
#define SPI_CS0_DDR		DDRB	
#define SPI_CS0			PB2

/*===============================================================================================
 Definition of output pins for LEDīs
================================================================================================*/
#define LED2			PD7		//Green
#define LED3			PD6		//Yellow1
#define LED4			PD5		//Red
#define LED5			PD4		//Yellow2
#define LED_PORT		PORTD	//LED-port = PORT D
#define LED_DDR			DDRD	//LED-direction = DDRD
/*================================================================================================
 Definition of testpoints
================================================================================================*/
#define TP1				ADC6	// Only A/D-converter input
#define TP2				ADC7	// Only A/D-converter input
#define TP3				PB1

/*================================================================================================
 Definition of input pins via dipswitch S1
================================================================================================*/
#define SW1				PC2
#define SW2				PC3
#define SW3				PC4
#define SW4				PC5
#define SW_PORT			PORTC
#define SW_DDR			DDRC
#define SW_PIN			PINC	//To read pin status when using pullup

/*================================================================================================
 Definition of UART port
================================================================================================*/
#define USART_RX		PD0
#define USART_TX		PD1
#define USART_DDR		DDRD
#define USART_PORT		PORTD
/*================================================================================================
 Definition for USB routines
================================================================================================*/
#define USB_ACTIVE		PD2
#define USB_ACTIVE_PIN	PIND
/*================================================================================================
 Definition of CC1100 routines
================================================================================================*/
#define GDO0			PC1
#define GDO0_PORT		PORTC		
#define GDO0_DDR		DDRC 		
#define GDO0_PIN		PINC

#define GDO2			PD3
#define GDO2_PORT		PORTD
#define GDO2_DDR		DDRD		
#define GDO2_PIN		PIND

#define CS_CC1100		SPI_CS0_NR
/*================================================================================================
 End
================================================================================================*/
#endif // HARDWARE_H